Brake Warning Light On: What to Check First
When the brake warning light comes on, the first thing to check is the parking brake. If it is fully released and the light stays on, the most common causes are low brake fluid, worn brake pads, or a problem in the hydraulic system. A red brake light should never be ignored, because it can signal a loss of braking power.
Red light vs. amber ABS light
Most cars have two different brake-related lights:
- Red “BRAKE” or (!) light. Tied to the parking brake and the main hydraulic system. This is the more urgent one.
- Amber “ABS” light. Means the anti-lock brake system has a fault. Your normal brakes usually still work, but the anti-lock function may not, which matters on wet roads.
If both lights come on together, treat it as serious and have the car checked before driving.
What to check first
- Parking brake. Make sure it is fully released. Some electronic parking brakes show a fault light if they do not release properly.
- Brake fluid level. With the engine off, look at the brake fluid reservoir under the hood. If the level is near or below the minimum mark, the pads may be very worn or there may be a leak.
- Leaks. Look inside each wheel and on the ground under the car for wet, oily spots.
- How the pedal feels. A low, soft or sinking pedal with the light on means stop driving.
Common causes of a brake warning light
- Low brake fluid. As pads wear, the fluid level drops. A sudden drop usually means a leak.
- Worn pads. Some cars have pad-wear sensors that turn on a light when the pads get thin.
- Failed sensor or switch. The fluid-level sensor or parking brake switch can fail and trigger the light.
- Hydraulic problem. A failing master cylinder or leaking line can reduce braking pressure.
- ABS fault. A bad wheel speed sensor, damaged wiring or an ABS module issue turns on the ABS light.
Is it safe to drive? If the red brake light is on and the pedal feels normal, drive carefully and get it checked as soon as possible. If the pedal is soft, goes low, or the car does not stop normally, do not drive it. If only the ABS light is on, your basic brakes should work, but leave extra stopping distance and get it diagnosed soon.
Why topping off the fluid is not a fix
Adding brake fluid may turn the light off for a while, but it does not explain why the fluid was low. Fluid that disappears is going somewhere: into worn pads or out through a leak. Both need to be addressed.
How we diagnose it
At Southern Motor Works we check the fluid, pads, lines and hoses, and use a scan tool to read brake and ABS codes. You get photos of what we find and a written estimate before any repair. Learn more about our brake repair in Duluth.
Get it checked in Duluth
Southern Motor Works is at 3446 Buford Hwy, Ste B, Duluth, GA 30096, open Monday to Friday 8 to 6 and Saturday 8 to 5. Book online in about a minute or call (770) 497-0771. You’ll see photos and a written estimate before any work starts, and repairs are backed by our 12-month/12,000-mile warranty (NAPA parts we install are covered for 2 years/24,000 miles nationwide). We work on all makes, foreign and domestic, and our team speaks English, Tiếng Việt and Español.
Frequently asked questions
Why is my brake light on when the parking brake is off?
The most common reasons are low brake fluid, worn pads or a faulty sensor. Check the fluid level and have the system inspected.
Can I drive with the ABS light on?
Usually your regular brakes still work, but the anti-lock system may not. Drive carefully and have it checked soon.
Will adding brake fluid turn off the light?
It may, but low fluid usually means worn pads or a leak. The cause still needs to be found.
